OperationLogin Change PIN Open Doors Manage Users Audit Report Config Report Configuration Daylight Savings System Clock Door Setup Delay & Timelock Lockout Schedule Idle Text PIN Parameters Service Installation Error Messages Alarm Sounding Alarm Wiring Electronic Parts Chassis Parts Overrides |
AuditLok XL - Alarm WiringStandard Alarm Output WiringAuditLok XL provides for duress and burglar alarm connections through a cable located at the back of the safe. Each alarm is switched via a SPDT relay with both normally open and normally closed contacts provided. When an alarm condition is activated, the appropriate relay will switch and remain in the alarm state until a valid key and PIN are presented. Bare terminations from the alarm cable are labeled as follows:• Burglar Common (blue*) • Burglar Normally Open (green) • Burglar Normally Closed (yellow) • Duress Normally Closed (black) • Duress Normally Open (red) • Duress Common (white) Wire colors may vary depending on when the safe was manufactured. Relay contact specifications are for 30 VAC/DC, 1A, power limited circuits only. |
|
Copyright
©2009 Updated 4-21-09 |
||