FKI Tech Info

Configuration
Clock
Keys
Doors

Service
Error Messages
Alarms
Keys
Display
Power
Doors
Locknet Safes
Vin 1 Parts
Vin 2 Parts

Vindicator - Managing Users

Enrolling User Keys

1. If available use an RGM (manager) key to enroll.
2. If a management key is not available, perform an override.
3. After entering PIN choose VINDICATOR LOCK and press SEL.
4. Choose ADMINISTRATION and press SEL.
5. Choose KEYS and press SEL.
6. Choose ENROLL and press SEL.
7. When prompted, insert the key to be enrolled, then press SEL.
8. Enter an ID number (usually the key holder's social security number) and press SEL.
9. Enter the key holder's name (see the Name Entry Letter Chart below). When done press SEL.
10. Enter a temporary PIN (1111) and press SEL (repeat to confirm, if required).
11. When prompted, present the key to write data.
12. After presenting the key the display should read DATA WRITTEN or similar. If not, repeat procedure.
13. Test key operation. This will force the operator to change the PIN and will verify operation.

Enrolling a Factory Key (Vin II Only)

1. The safe must be open and the inner board exposed. The safe must be powered.
2. Locate pins marked TB1 on the inner board. They are located between the alarm and AC input terminals.
3. Observe the front panel display while shorting these connectors.
4. When the display changes, unshort TB1 and press the down-arrow until the display reads ENROLL and press SEL.
5. When prompted, present the key.
6. When prompted for an ID number enter all 9's and press SEL twice.
7. For the key holder's name enter 15 10 12 29 27 24 34, then press SEL.
8. When prompted for a temporary PIN press ESC. This causes the PIN to remain at the factory preset of 1234.
9. When prompted present the key again. The screen should then read DONE.
10. Short TB1 again. Observe the screen change back to the date and time.