OperationChange PIN Open Door 1 Open Door 2 Armored Car User Chart Employee Count Add User Delete User View Audit Print Audit Configuration Time/Date Daylight Savings Delay Timelock Service Troubleshooting Error Message Parts List |
Sherlock - Inner Door DelayAbout Door DelayThe purpose of an inner door time delay is to protect employees during a robbery while still allowing controlled access for legitimate purposes. Most robbers are not willing to stay in a store long enough for delay to time out. They will take what they can from the outer compartment, but will leave drop money. Only the Owner key has permission to edit the inner door delay (the factory default is 15 minutes). When a delay is set, the inner door may be accessed after the delay is satisfied by logging in a second time during a period called the Access Time. Also programmable, the default access time is 5 minutes. Once the access time has expired, the delay must once again be satisfied before the door may be accessed again.Set Delay - Key VersionDelay may only be set using a "SUPER" key (Key 31).1. Present SUPER (31) key. 2. Enter your 4 digit PIN code. 3. Select TIMES (press “3”). 4. Select TIME DELAY (press “2”). 5. The current delay will be shown. To change the delay press “1.” Press “2” to accept the delay shown. 6. If you chose to change the delay, enter the new delay (the old delay will be shown below). Note that the minimum delay is 2 minutes. 7. The current access time will be shown. To change the access time press “1.” Press “2” to accept the access time shown. Note that the minimum access time is 2 minutes. 8. If you chose to change the access time, enter the new access time (the old access time will be shown below). 9. Remove your key return to the idle screen. Set Delay - Keyless VersionDelay may only be set by User 30.1. Press any number on the keypad to begin. 2. Enter a 2 digit User Number. 3. Enter your 6 digit PIN code. 4. Select TIMES (press “3”). 5. Select TIME DELAY (press “2”). 6. The current delay will be shown. To change the delay press “1.” Press “2” to accept the delay shown. 7. If you chose to change the delay, enter the new delay (the old delay will be shown below). 8. The current access time will be shown. To change the access time press “1.” Press “2” to accept the access time shown. 9. If you chose to change the access time, enter the new access time (the old access time will be shown below). 10. You will automatically return to the idle screen. Repeat this procedure to verify settings.
|
|||||
Copyright
©2009 Updated 4-24-09 |
||||||
