Easy 120Specs Installation Operation Theory Delay Settings Wiring Service Main Board Service Front Panel Service Power Service Vending System Service Door Service Manual Drop Service Parts Easy 120V / 120A Specs Installation Operation Theory Programming Wiring Service Main Board Service Front Panel Service Power Service Vending System Service Validated Drop Service Manual Drop Service Door Service Parts Smart Series Common Rules Audit Manage Users Open Door Vending Drops Reports Clock Setup Door Setup Vend Setup Validator Setup Location Setup Troubleshooting Keypad Replacement Parts List |
McGunn Smart Products - Keypad RepairKeypad ReplacementThe keypad is the most common failure item on all Smart products.1. You will need an extended allen wrench (5/32 hex screw) and 3/16 nut driver. 2. Unplug safe from power (under the control panel). 3. Remove black plastic plugs from each side of smart product logo. 4. Use Allen wrench to loosen 5/32 hex screws from each side of the control panel, but do not remove the screws. 5. Pull the control panel off front of safe and mount to safe so that the keyboard is exposed. 6. Unclip the plug from the keyboard. 7. Remove all four 3/16 nuts 8. Remove the keyboard, washers, spacer, and rubber keypad. 9. Replace the parts in the following order: a. rubber keypad b. metal spacer c. keyboard d. 3/16 nuts Note: DO NOT replace washers. 10. Clip gray cable rack to keyboard. 11. Mount control panel back to proper position. 12. Secure hex screws with allen wrench. CAUTION: Do not over-tighten - this could cause board damage. 13. Replace black plastic plugs. 14. Plug in safe power. 15. Safe should go to modem setup and back to McGunn Safe screen. If it says anything else contact Technical Service immediately (800.452.4655). |
|
Copyright
©2009 Updated 5-5-09 |
||