Easy 120Specs Installation Operation Theory Delay Settings Wiring Service Main Board Service Front Panel Service Power Service Vending System Service Door Service Manual Drop Service Parts Easy 120V / 120A Specs Installation Operation Theory Programming Wiring Service Main Board Service Front Panel Service Power Service Vending System Service Validated Drop Service Manual Drop Service Door Service Parts Smart Series Common Rules Audit Manage Users Open Door Vending Drops Reports Clock Setup Door Setup Vend Setup Validator Setup Location Setup Troubleshooting Keypad Replacement Parts List |
McGunn Easy 120 - OperationLoad Tubes• Open the outer door.• Put rolled coin or bills into empty tubes. • Insert full tubes into appropriate columns. Stickers on the interior of the vend assembly indicate the number of tubes in each column. Tubes may be loaded with either end facing forward. Vending Tubes• Insert the VEND key and turn to ON.• Press the number button corresponding to the column you want to vend from. • Rotate the release knob for the selected column. • Collect your tube from the dispensing tray. • The vend delay cycle must finish before you may vend again (the default delay is 2 minutes unless using the ALT VEND feature). Alt-Vend FeatureThis proceedure is used to enable a 30 second vend delay.• Insert the MGR key and turn to ON. • Press the ALT VEND button. • The vend delay switches to 30 seconds. • Press the ALT VEND button again to switch back to the normal vend delay. • Switch the MGR key to OFF to disable the 30 second delay feature. Manual Drops• Pull out the manual drop drawer.• Insert drop envelope into drawer. • Push manual drop in fully. The drop envelope will fall into a secure inner compartment. Normal Door Access• Insert the MGR key and turn to ON.• Press the DOOR button. • The DELAY/READY indicator will turn red (this indicates a delay is in progress). • The MGR key may be removed during the delay cycle if desired. • At the end of delay cycle both indicators turn green. • Insert the MGR key and turn to ON. • Press the DOOR button. • The DOOR indicator will turn off. • IMMEDIATELY turn the handle and open the door. • The door will automatically lock when you close the outer door. Armored Car Door Access• Insert and turn the ACO key.• While holding the ACO key, IMMEDIATELY turn the handle and open the door. • The door will automatically lock when you close the outer door. Inner Door Access• Open the outer door by normal or Armored Car proceedure.• Insert the inner door key into the inner door lock and turn. • The inner door pulls down to allow access to the inner compartment. |
|
Copyright
©2009 Updated 4-28-09 |
||