FKI Tech Info

LpLocks
S&G 6120/6123
LaGard 3600/33E
SmartGard
DigiGard

Keypad Lock - LpLocks EL-20 / EL-25

General Information

• 6-Digit code. Factory default = 123456.
• Blink and beep with each button press.
• Double-beep after last digit of valid code.
• Long beep after invalid entry. Four invalid entries results in 5 minute lockout (10 second flashes and long beep if any button is pressed).
• Triple-beep indicates lock bolt jam.
• Wait 20 seconds after a failed entry attempt before trying again.
• Factory code = 123456
• To change combo: Press and hold "0" until double-beep, enter old code (double-beep), enter new code (double-beep), enter new code again (double-beep). If any error occurs the old code remains.

EL-25 Opening Door with Delay

EL-25 Self Diagnostic

1. Press and hold "5" until double-beep.
2. Press each number button in sequence from "1" to "0" and listen for double-beep after each.
3. If each button double-beeps then all number buttons are working.

EL-25 Add/Change Second User

1. Press and hold "1" until double-beep and light remains on.
2. Enter primary code then enter new user code twice.
3. If each button double-beeps then all number buttons are working.
4. Test second user to verify operation.

EL-25 Delete Second User

1. Press and hold "3" until double-beep.
2. Enter primary code. Double beep indicates second user is deleted.

EL-25 Edit Door Delay

1. Enter code. (Double-beep indicates correct code).
2. Beep and flash every 10 seconds while delay is in progress.
3. When delay ends, the open period begins.
4. Open period indicated by rapid beep and flash once per second.
5. Press and hold "9" until double-beep and light turns on solid.
6. Enter primary code.
7. Enter delay minutes (two digits) and open period minutes (two digits). For example: 0502 = 5 minute delay and 2 minute open period.
8. Double-beep and light goes out indicates change successful. If there is no double-beep the change was not accepted.