OperationLog in & Log Out Door Access Manual Drop Validate a Bill Validated Drop Insta-Drop Extended Drop Manage Users Change Your PIN Change All PINs About Reports Print Reports Service Electrical Connections Printer Paper Silencing the Buzzer Error Messages Troubleshooting Tips Request Repair via Keypad Configuration Definitions CMP Application Initial Field Setup Setup Reports Server Ping Test Network Settings Regional (Clock) Supervision Setup Supervision Test Supervise Manually Commercial State |
XLV-iP CT8016Internet Connection TestIf the safe will connect to the EDGEiP server via network: Before connecting the safe to the LAN and doing the network setup required in later steps, connect your laptop to the store LAN using the cable that will be connected to the safe. Test the internet connection and ping the EDGEiP server. If the connection fails this will allow time for the customer to contact their network administrator to assist in solving the problem before you reach the last installation steps.1. Connect your laptop to the safe’s Ethernet cable. 2. Open a DOS Command Prompt. 3. At the prompt type “ping 206.196.5.167” then hit enter. 4. If you are unable to successfully ping the server, get the network administrator involved immediately. In most cases the network problem can be resolved while you complete the installation. Verify that you have the required TCP/IP settings for the safe: DHCP or IP Address, Subnet, and Gateway. If the problem cannot be resolved through the Network Administrator while you are on site contact the factory dispatcher immediately. |
|
Copyright
©2009 Updated 4-16-09 |
||